Burco TITAN RG90DF Manual de Instruções

TITANCommercial Catering RangeThese instructions cover the Burco Titan Dual Fuel 6 Burner Commercial Catering RangeRG90DF/NG, RG90DF/LP, SKU’s 4444403

USER’S GUIDESECTION 1 - ABOUT YOUR APPLIANCEAll models are tted with ame failure devices to shut off gas supply to burners if ames are extinguished

IMPORTANT INFORMATIONPLEASE READ THE FOLLOWING VERY CAREFULLY...AVOID MIS-USE!(MIS-USE OF THIS PRODUCT CAN BE HARMFUL).Guidance Rules for the SAFE US

SECTION 4 - CLEANING AND MAINTENANCEAll surfaces are easier to clean if spillages are removed before they become burnt on and if units are cleaned dai

OvenClean while oven is warm but not hot. The enamelled base plate lifts out. The shelf guides can be removed by removing the four xings. The oven ba

TITAN DUAL FUEL WIRING DIAGRAM Wiring colour code: Bk - Black, Bn - Brown, Bu - Blue, Gn/Y - Green/Yellow, Or - Orange, W - White, Y - Yellow.THERMAL

SPARES LIST Part Number Description Qty082982600 Burner cap assembly 6082982500 Burner skirt 6532991800 Oven door outer left hand side 1532991900 Oven

082758302 © 07.2011Customer helplineFor spares and after-sales service please contact Burco on:T: 0844 815 3755F: 0844 815 3748E: [email protected] Di

INTRODUCTIONThis appliance must be installed by a competent person in compliance with the installation and servicing instructions and national regulat

TO INSTALLATION, ESPECIALLY IN DAMP CONDITIONS, THE INSULATIONRESISTANCE OF THE ELEMENTS MAY FALL TO AN UNACCEPTABLELEVEL. (I.E. BELOW 2 MEGOHM).SHOUL

INSTALLATION AND SERVICE GUIDEIT IS MOST IMPORTANT THAT THESE INSTRUCTIONS BE CONSULTED BEFORE INSTALLING AND COMMISSIONING THIS APPLIANCE. FAILURE TO

the national requirements in force and shall be periodically examined and replaced as necessary.The installation must be tested for gas tightness. Det

Connect a manometer and check that supply pressure is correct when the oven burner is ignited and then turned to the highest temperature setting.1.8 B

2.4.3 Lighting sequenceImportant: Prior to operation, ensure ALL packing material has been removed from appliance.Hotplate1. Ensure mains gas is turn

3.1.5 CleaningBurners should be cleaned periodically to maintain maximum performance. Open top burners should be cleaned as detailed in User Instructi

3.8 RELAYS1. Remove cover plate from rear terminal box.2. Undo electrical connections from relay and remove xings.3. Replace in reverse order. Ele